Cookies in Use
quantek shop
  ALL PRICES ARE INCLUSIVE OF VAT & DELIVERY WITHIN THE UK
HomeLED EMERGENCY & NIGHT LIGHTS Automatic rechargeable power failure torch and night light 8 LED ceiling mounted automatic motion sensing light 10 LED Super Bright Automatic Wireless Motion Activated Battery Powered Night Light Universal Garage Door Replacement Remote Control Kit AllmaticAprimaticBenincaBFTCameCardaleCardinCasalDEAFAACGeniusGibidiHormanMarantecNicePrastelQuantekRIBSEASEAVSommerSteelineTelcom Ordering Contact

USEFUL LINKS
Links
   

Quantek RCS5D 433 MHz roller shutter remote control keyfob transmitter

Quantek two button remote control for use with RCS5D roller shutter control units. Coding is by DIP switches and the operating frequency is 433 MHz.

Supplied with 12 Volt LR23A battery and instructions.

Please note:

This transmitter was available working on two frequencies 418 and 433 MHz.
The 418 MHz version is no longer available.

If your roller shutter remote control is on the 418 MHz frequency you can replace the control unit, we have a new control unit and 2 transmitters for £70, you can find details by clicking this link Roller Shutter Remote Control.

To determine the frequency of your remote control, remove the cover, locate the silver disk on the circuit board (see photo) it may have a red sticker on it marked TEST OK, if so remove the sticker, then make a note of what is on the silver disk.

The 433MHz version is marked as follows:

RFM RO2101 OR BCT RTO 433 81 - There can be various letters and numbers either side of the 433, but as long as 433 is somewhere amongst them then this is the 433MHz version.

rcs5d circuit board

PCB reference TX4301.

quantek rcs5d remote control

 

RCS5D- 433 - £26
Including VAT & UK postage

add to cart

SETTING YOUR TRANSMITTER CODE
Part No. KEYD4333

Before you can use your transmitter you must first set the security code so that it matches your existing transmitters. To do this you will need to have one of your existing transmitters available.

Remove the screw located at the bottom of your existing transmitter and lift off the TOP half of the transmitter case, put the transmitter to one side, now remove the screw and case from the new transmitter.

Locate the row of 8 switches on your new transmitter and using the tip of a ball point pen adjust their position so they match your existing transmitter. Note that each individual switch can be set to one of three positions TOP (+), MIDDLE (0), or BOTTOM (-).

Check that you have set the switches correctly and replace the transmitter case and screw. Your transmitter is now ready to use.

RCS5D programming

 


nochex paypal

 

 free uk delivery

ALL PRICES ARE INCLUSIVE OF VAT


FEATURED PRODUCTS

motion sensing LED light

Motion Sensing Swivel Light


emergency power cut torch

Automatic Power Cut Emergency Torch


motion sensing ceiling hall light

Motion Sensing LED Hallway Ceiling Light

 

Terms & Conditions | Privacy Policy | Cookies
Copyright © 2016 QUANTEK TRADING LTD All Rights Reserved